User manual
IsatDock PRO - Installation & User Manual
2322
IMPORTANT:
Before docking the IsatPhone Pro to the docking
station, check that the USB cover is open, able to
swing free (without putting it in a “locked open”
position as illustrated in ‘B’) and ready for docking at
a 90-95 degree angle as shown on image ‘C’. If not
properly inserted, this could cause some problems
with the USB connection.
8) Cable Routing
The IsatDock provides three
dierent cable routing options when
installing the docking station.
Cables may exit via path ‘A’ that travels
around to the top of the dock allowing
for the interface cables to be run with
the external antenna connections.
Path ‘B’ directs cables out the base of
the dock while path ‘C’ results in cables
exiting to the side.
Optional through-wall
Right angled adapters are optionally tted to the
external antenna connectors to allow routing of
cables through a wall. A “clean” installation free of
any visible cabling can be achieved with the use
of right angled connectors and by running the
interface cables along path A.
A
B
C
IsatDock PRO Usage
Docking & undocking the
IsatPhone Pro handset
To place the IsatPhone Pro into the docking
unit, both the ‘covers’ on the external antenna
connectors and the USB/Audio connectors
need to be opened.
1. The antenna ‘cover’ must be placed at 90
degrees to the antenna connector cavity and
run parallel to the top edge of the phone.
2. The ‘cover’ in the base of the phone should
be in the a 90 degree opened position.
1
1. To dock the handset, align the IsatPhone Pro
with the phone tray and slide the handset
down until it seats ush to the bottom of
the tray. Swing the phone down into the
cradle by applying pressure to the top of the
handset. An audible ‘click’ is heard when the
phone is in the docked position.
2. To remove the handset from the cradle,
press the EJECT button at the top of the
docking station. The dock will swing out
and the handset can be removed.
Eject Button
1
2
SMA Adaptor (GPS)
TNC Adaptor (GSPS)
IsatDOCK
IsatPhone PRO
A B C