User manual

IsatDock PRO - Installation & User Manual
1716
2a) Wall Mounting Orientation
There are nine screw holes available for mounting
the bracket to a wall. It is recommended that
a minimum of 2 screws are used to ensure the
docking station is mounted securely.
There are four keyhole shaped slots in the
mounting bracket that mate with feet on the
rear of the docking station. To attach the
bracket, the larger end of the keyhole will pass
over the feet. The bracket is then slid up to lock
the feet into the narrow section of the keyhole.
NOTE
Refer to the section “Antenna Installation” for more
information on antenna placement and installation.
Only Beam approved antenna cables should be used
with all docking stations and antennas.
WARNING
DO NOT pull with force on the cables from the
rear of the IsatDock PRO. Please install strain relief
clamping for the antenna cables where required.
Correct installation of the antenna system is a vital
part of the IsatDock PRO system, to ensure reliable
functionality, and drop-free calls.
WARNING
Changes or modications not expressly
approved by BEAM Communications could void
the product warranty.
WARNING
To satisfy FCC RF exposure requirements for mobile
transmitting devices, a separation distance of
55cm or more should be maintained between the
antenna of this device and persons during device
operation. To ensure compliance, operations at
closer than this distance is not recommended.
ISD700
Directional/Fixed Antenna
(Passive) with Bracket
Transport Antenna
(Active)
ISD715
Magnetic
Mounting
ISD720
Bolt
Mounting
Security Bolts
Two security bolts ensure the PRO docking unit
is rmly xed to the wall and only removed by an
‘authorized’ (the security key holder) personnel.
Once the IsatDock PRO is tted to the wall,
these two security bolts prevent the docking
station from sliding back up freeing the dock.
The security bolts are 4mm in diameter and have a
slot for a at blade screwdriver.
The bolt under the privacy handset mounting
cup must be tted prior to the cup being screwed
into place. The second bolt is placed under
the IsatPhone Pro in the recess for the handset
antenna cover. Both bolts are then covered with
plugs. As the second bolt is under the IsatPhone
Pro, access to the bolt is denied when the handset
is locked into the cradle.
Once the dock as been locked onto the mount-
ing bracket on the wall, two security bolts are
then slid into place locking the dock to the wall.
2b) Desk Mounting Orientation
The IsatDock PRO supports a desk mount
conguration. Depending on the users
requirements the docking station supports both
a at and raised orientation on the desk.
To congure the IsatDock for a desk installation:
1. Fit the mounting bracket to the back of
the IsatDock as shown in section (2a) wall
mounting directions.
2. Flip the feet out if required and locate the
IsatDock on the desk.
When desk mounting, the security bolts are not
required to be tted.
a
b c
Slide the dock down
Fit the docks feet in the large holes of the bracket
Final lock position