User guide

FX2600 FAX ADAPTER USER GUIDE
9
1. Set Country Code
The Fax Adapter by default is configured to work correctly with North American fax machines,
however can be changed to support fax machines from a range of other countries.
This is done by entering a command in Hyperterminal. If you are unsure on how to connect to the Fax
Adapter using Hyperterminal, see the section Connecting to the Fax Adapter with Hyperterminal.
Make sure you know your country code before continuing. These can be found in the Fax Adapter
User’s Guide if you are unsure, and will be entered as a 3-digit number. (For example USA would be
001 and the UK would be 044).
Once at the command prompt in Hyepterminal, type in AT and then hit ENTER. The Fax Adapter
should respond with “OK”.
Type ATCxyz (where xyz is your 3-digit country code).
Type AT\S to verify that the Fax Adapter has stored the country code correctly.