Installation guide

Terra 800
Quick Start Guide
www.beamcommunications.com
PART #: USRQSG006701
BEAM Communications Pty Ltd
8 Anzed Court, Mulgrave
Victoria, 3170, AUSTRALIA
Web: www.beamcommunications.com
Information: [e-mail]
Support: [e-mail]
Tel: [phone]
Fax: [phone]
2. SIM Installation
REAR SIM CARD
If your Service Provider has not installed the SIM card for you, follow
these steps to install.
1. Turn the Terminal’s source of power
OFF. Failure to turn it OFF can result in
corruption of your SIM card memory.
2. The Rear SIM is accessed from the rear
of the terminal. Undo the screw and
remove the cover.
3. The SIM connector is shown highlighted
below. Slide the tray guide into the open
position with your nger or thumb.
4. Once opened, raise the SIM tray as shown
below.
5. Gently insert the SIM card into the tray slots
making sure that the golden contacts are
facing downwards.
6. Lower the tray and slide the tray guide into
the lock position.
7. Replace the SIM cover, and tighten the
screw.
SIDE SIM CARD
The Side SIM port can be used on its own, or in addition to the rear port.
1. Insert the SIM with gold contacts
facing down
2. Close the SIM door, and ensure that it
“clicks” shut. This indicates the water
resistant seal has been engaged.
3. Power the terminal back ON.
4. The SIM will automatically register on
the SIM service of the Side SIM.
NOTE
Gold contacts on SIM must be facing downwards.
The Side SIM Port only accepts full size SIM. If required, you can ret your SIM
to the outer card using adhesive tape as illustrated below:
1. Terra 800 Equipment Overview
1. Interchangeable mounting cup
(spring or springless)
2. Privacy handset
3. Speaker
4. Microphone
5. Status LED
6. Screen display
7. Dial keypad
8. Side SIM card port
(full size rapid user)
9. Function keypad
10. Mini USB port
11. Back panel connectors
a. RJ9 privacy handset
b. RJ11/POTS interface
c. Auxiliary device port
d. DC power and accessory input
e. Ring alert / audio system mute
1
2
3
4
6
7
8
9
10
5
11
a
b
e
c d
3.
4.
5.