Installation Guide
10 beamlabs.io 1-800-436-9186
INSTALLING BELT (BU800)
To prevent SERIOUS INJURY:
• DO NOT connect power until instructed.
• Keep hands and fingers clear from sprocket during
operation.
• Wear gloves when installing chain/belt and cable.
• Keep hands and fingers away from joints and
possible sharp edges.
WARNING
Bring belt and trolley sha together, check to make sure the belt is not twisted. Connect belt and trolley sha
with master link. If belt connector and trolley sha are not close enough to connect with master link, loosen belt
connector to create more slack.
Adjust belt tension by turning belt connector until belt is about 1/4 inch (.64cm) above the base of rail. Once
proper tension is achieved tighten lock nut against belt connector.
Tighten until...
Belt connector
1/4 inch
(.64 cm)
Nut