Installation Guide

12 beamlabs.io 1-800-436-9186
MOUNTING HEADER BRACKET
Look in the box for:
Mark the center line above the door with a pencil. Open door to the highest point of travel.
Header Bracket 2 x Lag Screws
5/16" x 1-1/2"
To prevent SERIOUS INJURY:
• DO NOT connect power until instructed.
• The header bracket MUST be SECURELY fastened
to the structural support on the mounting wall or
ceiling, otherwise other door may not reverse when
required. DO NOT install the header bracket over
drywall.
• Concrete anchors MUST be used when mounting
the header bracket into masonry.
• NEVER try to loosen, move or adjust garage door
springs, cables, pulleys, brackets, or hardware.
• Contact a qualified garage door service technician
if your door binds, sticks or is unbalanced. An
unbalanced door might not reverse when required.
Take a level, measure and mark highest point of the
door on the wall. Raise level to clear torsion bar if
required, then mark highest point.
Measure 2 - 1/4 inch (5.7 cm), mark two holes of
header bracket. Drill two holes and fasten header
bracket using screws.
Center Line
2-1/4 inch
(5.7cm)
WARNING
Highest Point
of Travel