Installation Guide

beamlabs.io 1-800-436-9186 19
CONNECTING DELUXE DOOR CONTROL (BU400, BU800)
Look in the box for:
*NOTE: Your opener will contain one of two door controls. Follow the instructions corresponding to the control provided.
To prevent SERIOUS INJURY or DEATH from electrocution or fire:
• Be sure power is NOT connected BEFORE installing door
control.
• Connect door control ONLY to 12 VOLT low voltage wires.
To prevent SERIOUS INJURY or DEATH from a closing garage
door:
• Install door control within sight of garage door, at a minimum
height of 5 feet (1.5 m) so small children are not able to reach
it, and away from ALL moving parts of door.
• NEVER permit children to operate or play with door control
or remote controls.
• Activate garage door opener ONLY when door can be seen
clearly, is properly adjusted, and there are no obstructions to
door travel.
• ALWAYS keep a moving garage door in sight until completely
closed. NEVER cross path of moving garage door.
WARNING
Wire deluxe door control to power
head as shown.
1. Strip 7/16 inch (11 mm) of insulation from wire and separate wires.
2. Connect one wire to each of the two screws on the back of the
door control. *DO NOT RECOMMEND USING PRE-EXISTING
WIRE*
3. Mark the location of bottom mounting hole and drill 5/32 inch hole.
4 Install the bottom screw and allow 1/8 inch (3 mm) to protrude
from wall. Note: Use anchors if mounting to drywall.
5. Position bottom hole of door control over the screw and slide
down into place.
6. Li actuation button and mark the top hole. Remove the door
control from wall and drill 5/32 inch hole for top screw
7. Position bottom hole of door control over the screw and slide
down into place. Fasten the top screw
Deluxe Door
Control
Connect plug from deluxe door control to wall panel outlet on the back panel of the power head.
**If using pre-existing wire you may cut off plug and splice to existing wire**
Min. 5 feet
(1.52 m)
above floor
See how to use deluxe door
control on page 20.
Bottom screw
Top screw
Deluxe Door
Control*
2 x Lag Screws
#6 x 1-3/8"
2 x Anchors
1/4" (6mm)