Installation Guide
beamlabs.io 1-800-436-9186 23
TRAVEL LIMIT ADJUSTMENT - UP LIMIT
Press and release “Limit” button, the green (UP) LED will illuminate. Press and hold the “Up” button until door
reaches desired open position.
Press and release
LIMIT just once
Press and release LIMIT just once
To prevent SERIOUS INJURY or DEATH from
improper Force Adjustment:
• YOU CANNOT adjust force manually to compensate
for binding or sticking of the garage door. Call
a qualified garage door service person to make
necessary adjustments in case of binding.
• YOU CANNOT manually increase the force required
for closing the door.
• Aer ANY adjustments, Safety Reversal Test MUST
be performed to ensure the door reverses on contact
with a 1-1/2 inch (3.8 cm) high object (2x4 laid flat).
Press and hold UP
* DO NOT HIT STOP BOLT *
There should be a minimum 2 inch (5 cm) gap
between trolley and stop bolt.
Once the door is at the desired open position,
press and release the “Limit” button once. The
“OK” LED flashes and turns off. The UP Limit has
now been set.
Minimum 2 inch (5 cm) gap
Stop Bolt Trolley
NOTICE:
Travel limits and auto force setting must be set for
the opener to work. All steps on pages 23-25 must
be followed.
WARNING
Desired
UP limit
Before programming the garage door opener please ensure the following steps are completed:
Door is fully closed. Photo eyes are aligned. Trolley sha is engaged with trolley.