Installation Guide

26 beamlabs.io 1-800-436-9186
Open door using
door control.
Test the Safety Reversal System
FINAL ADJUSTMENTS AND TESTING
Test the Photo Eye Safety System
1. Open door by using the door control.
2. Make sure photo eye safety system is aligned with
both the red and green LEDs illuminated. If not,
refer back to pages 17-18.
3. Place the garage door opener carton in the path of
the door.
4. Keeping the door in sight press the door control
or remote control to close the door
Door should NOT move more than 1 inch (2.5 cm) and
the garage door opener will beep and flash 20 times.
1-1/2 inch (3.8 cm) solid object
To prevent SERIOUS INJURY or DEATH from a
closing garage door:
• The Safety Reversal Test MUST be conducted ONCE
A MONTH.
• NO ONE should cross the path of moving door
during operation and/or testing.
• Aer ANY adjustments to the door system, the
Safety Reversal Test MUST be performed to ensure
the door reverses on contact with a 1-1/2 inch
(3.8 cm) thick (2x4 laid flat) object.
• The Photo Eye Safety System MUST be properly
aligned, and tested regularly.
Place a 1-1/2 inch (3.8cm)
flat solid object on the floor,
centered under the garage door.
Use door control or remote to close door.
Door MUST reverse* upon making contact
with the object.
beeps upon
contact
Emitter Sensor
Green LED
Flashes
Red LED
OFF
20 beeps and
reverses upon
obstruction
* If door does not reverse, return to page 21, reprogram the operator, taking care to set the down limit lower than initially.
NOTICE:
Travel limits and auto force setting must be set for
the opener to work. All steps on pages 23-25 must
be followed.
WARNING