Instructions / Assembly

beamlabs.io 1-800-436-9186 9
INSTALLING BELT (BU800)
Look in the box for:
Trolley Sha/Belt Assembly
Master Link
Pull trolley lock lever down to unlock. Insert screwdriver
into the hole located on the rail-header segment. Slide
the trolley up to the screwdriver. The trolley must stay in
this position for proper alignment of the belt. Insert the
trolley sha through the trolley and pull lever back up.
Sprocket teeth must engage the belt. Continue
pulling belt towards trolley.
Insert belt through pulley slot and toward power
head. The ribbed side must contact the pulley and
should be facing inwards.
Pull belt along the rail towards power head and
loop belt around the belt sprocket.
To prevent SERIOUS INJURY:
• DO NOT connect power until instructed.
• Keep hands and fingers clear from sprocket during
operation.
• Wear gloves when installing chain/belt and cable.
• Keep hands and fingers away from joints and
possible sharp edges.
WARNING
Chassis
Loosely attach trolley sha with belt connector. 5 complete turns will be sufficient.