Instructions / Assembly

beamlabs.io 1-800-436-9186 35

TROUBLESHOOTING

NOTICE

Opener will not work until you set the travel limits

and the auto force adjustment. You must follow all

steps located on pages 23-25.

So open / So close feature: opener is designed

to start slowly, accelerate to full speed, then slowly

stop. So open/close is designed to reduce strain

on openers components and to improve opener

longevity.

Problem Possible Cause / Solution

Opener does not close and beeps x 20 The photo eye may be obstructed, not properly aligned or

installed, check connection and alignment by referring to

page 17.

Opener does not respond to • Refer to page 27 to reprogram remote control.

remote control

• Check remote control battery and vacation switch if

deluxe door control is installed.

Opener stops before reaching full Travel Limit is not properly set, check adjustment

open / close position referring to pages 23-25. Conduct safety reverse test aer

ANY adjustment.

Door reverses unintentionally • Make sure the photo eye safety system is aligned

and clear of obstructions.

• Refer to page 3 to check the door balance

• Refer to pages 23-25 to reset travel limits and force

adjustment.

Door reverses and courtesy light ﬂashes Refer to pages 23-25 to reset travel limits and force

adjustment.

Opener does not close the door and

The photo eye safety system is misaligned or

LED on one of photo eyes ﬂashes obstructed, refer to page 17-18 for proper alignment.