Instructions / Assembly

2 beamlabs.io 1-800-436-9186

BEFORE YOU BEGIN SAFETY INSTRUCTIONS

To reduce the risk of severe injury or death:

1. READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.

2. Install only on a properly balanced garage door. An improperly balanced door has the

potential to inﬂict severe injury. Have a qualiﬁed service person make repairs to cables,

spring assemblies, and other hardware before installing the opener.

3. Remove all ropes and remove or make inoperative all locks connected to the garage

door before installing opener.

4. Where possible, install the door opener 7 feet (2.13 m) or more above the ﬂoor. For

products having an emergency release, mount the emergency release within reach, but

at least 6 feet above the ﬂoor and avoiding contact with vehicles to avoid accidental

release.

5. Do not connect the opener to source of power until instructed to do so.

6. Locate the door control button: (a) within sight of door, (b) at a minimum height of 5 feet

so small children are not able to reach it, and (c) away from all moving parts of the door.

7. Install the Entrapment Warning Label next to the wall-mount control button in a promi-

nent location.

8. Aer installing the opener, the door must reverse when it contacts a

1-1/2 inch (3.8 cm) high object (or a 2x4 board) laid ﬂat on the ﬂoor.

9. NEVER try to remove, loosen, move, or adjust garage door, cables, pulleys, brackets,

and door springs. All are under EXTREME tension.

10. To reduce the risk of injuries to persons – use this operator only with residential sectional

garage doors. Only enable the unattended operation feature when installed with a

sectional door. The Smart Door Controller should be used only on sectional doors and

with garage door openers made aer 1993 with a photo eye safety system.

WARNING

Measure door height. Check mounting

locations.

Are additional

reinforcement material

needed?

If over 7.5 feet (2.28 m),

rail extension kit will be

needed.

See page 3

Check your toolbox. Do

you have all the tools

needed?

7.5 feet

(2.28 m)