Operation Manual

resisto
r
IN OUT IN OUT IN OUT
120Ω
DIP switch settings
Dipswitch 1 2 345678910
Auto
(switches between flash/fade) X X X XXXX
√
X
√
Sound activated X X X X X X
√
XX
√
Flash 0 0 0 0 0 0 X X
√ √
Dip 1-6 Flash speed
Full On 0 0 0 0 0 0 X
√ √ √
Dip 1-6 Dimmer
Fade In-Out 0 0 0 0 0 0
√
X
√ √
Dip 1-6 Fade speed
Fade Out 0 0 0 0 0 0
√ √
X
√
Dip 1-6 Fade speed
DMX 0 0 0000000X Dip 1-9 Address set
Notes:
① √ means on, X means off, O means on and off is selectable
② When in DMX control, the address can be set by dipswitches 1 – 9.
③ 0x - 16x means 1 time - 32 times of speed. Speed switches can be any combination, adjustment range is
(0x~31x).
DMX Settings
A DMX signal terminator is recommended to avoid a bad signal caused by other electrical devices. A DMX terminator is a
XLR connector with a 120Ω resistor between pin 2 and pin 3 of the XLR connector. Connect it to the last OUTPUT socket
of the final light.
See picture:
DMX Channel DMX Value Display Specifications
1. Total function control
0~36
37~72
73~108
109~146
147~186
187~216
217~255
Dimmer (channel 2 dimmer 0-100%)
Flash (channel 2 flash speed (slow-fast)
Fade (channel 2 fade speed (fast – slow)
Fade out (channel 2 fade speed (fast – slow)
Fade in (channel 2 fade speed (fast – slow)
Auto (switches between flash/fade programmes)
Sound activated
2. Dimmer/Speed control 0~255 Dimmer/speed control Ch1