Operation Manual

CONTROLS
Front
1. Channel indicators
2. Channel fader: Controls the level in assign programm mode or the channels in manual mode
3. Latch button (CH 9 – CH 16): It functions as assign latch or channel latch in manual mode
4. Flash button (CH 1 – CH 16): It functions as assign flash or channel flash in manual mode
Shift + flash button: Changes the blind setting in chase mode and when blind enable indicator is lit
5. Master fader: This fader functions as a master fader for fader 1 – 8 or in chase mode and cross function as
master for the pattern. The patterns are executed step by step by moving the master fader
6. M indicator: Indicating the master status for fader 1 – 8
7. A & B indicators: Indicating the master status of two following steps in cross mode
8. Level knob: This knob functions as a master for the pattern in chase mode
9. Speed/Fade time know: This knob controls the chasing speed from 10 steps/sec to 1 step/5min and time from
0.1sec to 5min in chase mode.
10. Audio knob: This knob controls the sensitivity in audio chase mode
11. Display: It shows the present operating mode and program options
12. Cross button: This button enters or leaves cross mode in chase mode and when cross on indicator is lit
13a. Pattern ▲ button: Press to increase the left two digits by one. Pressing this button for more than one second
increases the digits quickly from present counter till the maximum and then increase from the minimum to
maximum etc.
13b. Shift + Button setup: Pressing shift + button setup together sets the channel fader. Latch button and flash
button, each press makes a new setting, the matching indicator is lit.
14a. Pattern ▼ button: Press to decrease the left two digits by one. Pressing this button for more than one second
decreases the digits quickly from present counter till the maximum and then increase from the minimum to
maximum etc.
14b. Shift + Fade time setup: Pressing shift + fade time setup sets the fade time. When fade time indicator is not lit,
fade time is disabled. If step time indicator is lit, fade time is set by the speed knob and is identical to the step
time.
15a. Step ▲ button: Press to increase the right two digits by one. Pressing this button for more than one second
decreases the digits quickly from present counter till the maximum and then increase from the minimum to
maximum etc. In chase mode, press this button to execute the pattern by one step. Pressing for more than one
second allows to execute the pattern by ten steps per second.
15b. Shift + cross setup button: Pressing shift + cross setup together enables or disables cross mode. If cross off
indicator is lit, press the cross butoon to enter or leave cross mode.
16a. Step ▼ button: Press to decrease the right two digits by one. Pressing this button for more than one second
decreases the digits quickly from present counter till the maximum and then increase from the minimum to
maximum etc. In chase mode, press this button to execute the pattern by one step. Pressing for more than one
second allows to execute the pattern by ten steps per second.
16b. Shift + blind button: Pressing shift + blind together enables or disables blind mode. In blind mode the enable
indicator is lit.