Operation Manual

Rear
1. DC Input
2. Power switch
3. DMX polarity selector
4. DMX output
5. Midi thru: Transmit midi data received on the midi in connector
6. Midi in: Receive midi data
7. Audio line input: For connection with for example a mixer (100Mv to 1Vpp). If it is connected, the built-in
microphone is disabled. When not connected the built-in microphone is enabled.
8. Foot control: Can be used to connect a foot controller for remote control
PIN FUNCTION
1 Step up
2 Pattern up
3 Stand by
4 Full on
5 Common
MIDI setting
1. Note data:
Note nr velocity Function
22 - 81 Master level for the pattern Turn on/off 1 - 60 patterns
82 - 97 channel dimmer Identical to that set by flash 1 - 16
99 Full on
101 Execute the pattern by one step
102 Change the stand by status
2. If midi signal disappears, 10 minutes later the matching indicator is off and the midi settings are dumped.
3. To receive midi signal, set the midi channel according to the setting of midi controller
4. The patterns turned on by midi are not controlled by level knob and not showed in the display. All turned on
patterns are executed synchronously and the terminal level is synthesized by the levels of the turned on
patterns.
Operating instructions
1. Run pattern
• Press appropriate function button(s) to select desired chasing mode from auto, manual, audio and tap sync.
The display shows the pattern and the step.
• Press pattern ▲ or pattern ▼ to select desired pattern from 30 built-in patterns (31 – 60) and 30 variable
patterns (1 – 30). If the right two digits show 00, the pattern is blank or had been deleted.