Reference Manual
Table Of Contents
- Digi XBee® 3 RF Module Hardware Reference Manual
- General XBee 3 specifications
- IEEE 802.15.4-specific specifications
- Mechanical drawings
- Pin signals
- Design notes
- Regulatory information
- XBIB-C development boards
- Manufacturing information
- Troubleshooting
General XBee 3 specifications Electro Static Discharge (ESD)
Digi XBee® 3 RF Module Hardware Reference Manual
11
GPIO electrical specification Value
Input pull-down resistor value
40 kΩ (typical)
Output voltage for logic 0 0.2 x VCC (maximum)
Output voltage for logic 1 0.8 x VCC (minimum)
Output source/sink current 50 mA (maximum)
Total output current (for GPIO pads) 200 mA (maximum)
Electro Static Discharge (ESD)
XBee 3 RF Module pins are tolerant to human-body model ± 1.5 kV.
Note Take care to limit all electrostatic discharges to the device.