Reference Manual

Regulatory information Europe (CE)
Digi XBee® 3 RF Module Hardware Reference Manual
52
The CE mark shall consist of the initials “CE” taking the following form:
n If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
n The CE marking must have a height of at least 5 mm except where this is not possible on
account of the nature of the apparatus.
n The CE marking must be affixed visibly, legibly, and indelibly.
Important note
Digi customers assume full responsibility for learning and meeting the required guidelines for each
country in their distribution market. Refer to the radio regulatory agency in the desired countries of
operation for more information.
Declarations of conformity
Digi has issued Declarations of Conformity for the XBee 3 RF Modules concerning emissions, EMC, and
safety. For more information, see www.digi.com/resources/certifications.
Antennas
The following antennas have been tested and approved for use with the XBee 3 RF Module:
All antenna part numbers followed by an asterisk (*) are not available from Digi. Consult with an
antenna manufacturer for an equivalent option.
n Dipole (2.1 dBi, Omni-directional, Articulated RPSMA, Digi part number A24-HABSM)
n PCB antenna (surface mount boards only) (0.0 dBi)
n Chip antenna (micro form factor only) (0.0 dBi)
n PCB antenna (through-hole boards only) (-0.5 dBi)
n Integral Dipole (USB Adapter only) (0.87 dBi)