Use and Care Manual

36BB, 36BDB

BRUSH BEAST

Rev: Mar2011

BRUSH BEAST Brush Mower

Step 5: Fuel Tank Connections

Locate the fuel tank on the fuel tank bracket with the recessed

area pointing toward the rear so any spills drain away from the

engine. Align the fuel valve in the center of the clearance hole.

Place the fuel tank straps into position, wrapping them around the

tank and the bracket.

Once the fuel tank and straps are in place, securely tighten the

straps using the bolts provided. Next, firmly attach the fuel line to

the fuel valve nipple. Tighten all connections to ensure they are

firm and secure so the fuel system is tightly attached.

GASOLINE IS HIGHLY FLAMMABLE AND EXPLOSIVE. FUEL

LEAKS, A LOOSE FUEL TANK, OR A LOOSE FUEL VALVE CAN LEAD

TO SEVERE INJURY OR DEATH. ENSURE ALL CONNECTIONS ARE

SECURE AND INSPECT THOROUGHLY FOR ANY POTENTIAL

LEAKS IN THE FUEL SYSTEM. IF YOU FIND A LOOSE CONNECTION

OR A LEAK, MAKE AN IMMEDIATE REPAIR OR ASK FOR

ASSITANCE FROM A PROFESSIONAL MECHANIC OR SERVICE

CENTER.

Step 6: Brake Set-up

1. Set the brake bar 3/4-1 inch from the tire.

2. With the brake pivot

leaning slightly

forward, install the

washer and pin.

Assembly Instructions

DO NOT OPERATE THIS BRUSH MOWER IF ANY

COMPONENT OF THE FUEL SYSTEM IS LOOSE OR

LEAKS GASOLINE!

WARNING

Battery pan

Note: Verify tire pressure.

Do not exceed the

recommended 24 PSI

maximum.

3. Slide the brake handle to the bottom of the slot then

connect the brake pivot to the brake handle.

4. Slide the brake handle to

the Set position to clamp

the brake bar against the

tire.

Note: If more or less brake

force is necessary or desired,

repeat the procedure, changing the gap in Step 1.