Use and Care Manual
ii
54ZB, 62ZB
Z
-
Beast Finish Mower
Rev: AUG2014
Z- BEAST
This manual contains important safety instructions for Finish Mowers
READ SAFETY WARNINGS AND OPERATING INSTRUCTIONS CAREFULLY
SAVE THESE INSTRUCTIONS.
This owner’s manual is considered a permanent part of the finish mower and should
remain with the finish mower if resold. Should the owner’s manual become damaged or
illegible, replace immediately.
WARNING
The engine exhaust from this product
contains chemicals known to the state
of California to cause cancer, birth
defects, or other reproductive harm.
NOTICE OF REQUIREMENT OF SPARK ARRESTER MUFFLER
This equipment may create sparks that can start fires around dry vegetation. California Public Resources
Code Section 4442.6 provides that it is unlawful to use or operate an internal combustion engine on any
forest-covered, brush-covered, or grass-covered land unless the engine is equipped with a spark arrester
maintained in effective working order. A spark arrester is a device constructed of nonflammable materials
specifically for the purpose of removing and retaining carbon and other flammable particles over 0.0232 of
an inch in size from the exhaust flow of an internal combustion engine that uses hydrocarbon fuels or
which is qualified and rated by the United States Forest Service. Other states or federal areas may have
similar laws. The operator should contact local fire agencies for laws or regulations relating to fire
prevention requirements. CONTACT THE ENGINE MANUFACTURER IF YOUR AREA REQUIRES A SPARK
ARRESTER.
Copyright© 2010 by GXi Outdoor Power, LLC. All rights reserved.
No part of this publication can be reproduced or distributed without prior written permission of GXi Outdoor Power, LLC
Clayton, NC 27520 USA.
DEK is a registered trademark of GXi Outdoor Power, LLC
GXi Outdoor Power, LLC reserves the right to discontinue or change specifications or design at any time without notice
and without incurring any obligation whatsoever.
The information and specifications included in this publication were in effect at the time of approval for printing.










