Use and Care Manual

8
UNPACKING
Prior to tool assembly and use, read
this manual thoroughly to familiarize
yourself with proper assembly, maintenance and safety
procedures.
Check shipping carton and machine for damage
before unpacking. Carefully remove components in
top foam layer. Remove the top layer of foam then
remove all components in the bottom layer of foam.
Lay out all parts on a piece of cardboard or other
clean, flat surface. Always check for and remove
protective shipping materials around motors and
moving parts. Do not discard shipping carton and
packing materials until you have carefully inspected the
contents, assembled the machine and are sa
tisfied that
it operates correctly.
Compare package contents to Component Parts List
and Hardware Package List prior to assembly to make
sure all items are present. Carefully inspect parts to
make sure no damage occurred during shipping. If any
parts are missing, damaged or preassembled, do not
assemble. Instead, call Service Center at
for assistance.
After assembly remove any protective materials and
coatings from all of the parts and the tile saw. The
protective coatings can be removed by spraying
WD-40® on them and wiping them off with a soft cloth.
This may n
eed to be redone several times before all of
the protective coatings are removed completely.
SHIPPING CONTENTS
Description (QTY)
1. Water tray (1)
2. Main frame (1)
3. Miter guide (1)
4. Worktable (1)
5. Saw arm, head assembly (1)
5b. Blade wrench (1) & Allen wrench (1)
Hose (1)
Pump (1)
H1. M10 X 60 Hex Head Screws (3)
H2. 8mm Allen wrench (1)
;OLWHY[UHTLZHUKWHY[ U\TILYZ JVYYLZWVUK [V [OVZL\ZLKPU[OL
(ZZLTIS`6WLYH[PVUZHUK4HPU[LUHUJLZLJ[PVUZVM[OPZTHU\HS
1
2
3
4
5
7
6
5b
H1
H2
6.
7.
9
ASSEMBLY
(continued)
INSERT THE WATER TRAY
Ensure the saw is on a level
and stable surface that will
support weight of saw, tray and contents.
s (See Figure 5) Insert water tray (1) by
sliding it into the frame as shown. The lip
of the tray should rest on top of the left
and right rails of the main frame.
If using with a stationary or portable stand
s The Beast 7 can also be used with a
stationary or portable stand which can be
purchased separately. For instructions on
properly mounting and securing this tool
to a stand, refer to the owner’s manual
shipped with your stand.
If you are using this tool
with a stationary or portable
stand, sold separately, make sure stand
assembly is on a level and stable surface
that will support weight of saw, tray and
contents
1. Position the saw arm assembly (5) so that
the two pins (C, Fig. 6) on the mounting
plate align with the two middle holes in
the main frame (2)
2. Insert the pins into holes.
3. (See Figure 7) Secure the saw arm
assembly to the main frame using the
three M10 X 60 hex head screws (H1)
from the inside of the main frame.
Tighten using the supplied 8mm Allen
wrench (H2).
FIGURE 5
FIGURE 6
FIGURE 7
ATTACH THE SAW
ARM ASSEMBLY
H1
C
1
The part and hardware names and numbers correspond to those used in Saw Features on page 7
and the Shipping Contents on page 8 & 9.
8 9