User's Manual

.13. .14.
Upgrading Wireless Connection Mode
For SFQ-01 user, you can purchase a 2.4G wireless
receiver to upgrade the connection mode by
replacing the receiver located in the storage
compartment on the back of unit.
For SFQ-01W user, you can purchase a Bluetooth
receiver to upgrade the connection mode by
replacing the receiver located in the storage
compartment on the back of unit.
If you have any question, please consult your
dealer.
1. Open the cover of receiver storage compartment
located on the back of unit.
2. Remove the "receiver" from the storage
compartment.
l Make sure the new "receiver" is well
connected to the system.
4. Close the "receiver" storage cover.
3. Set a new "receiver" into the storage compartment
as shown.
DO NOT REMOVE RECEIVER UNLESS YOU ARE UPGRADING WIRELESS CONNECTION MODE. PLEASE
VISIT SOUNDFREAQ.COM FOR FURTHER DETAILS.
"THIS SIDE UP" is
marked on the
receiver.
l When a 2.4G wireless connection is established
successfully, the indicator starts blinking
slowly.
6. Select the desired music and press "Play"
button on your device. The system starts
playing the audio automatically.
l Try again above step 5 if the Pair indicator on
the unit lights solidly.
Unit Unit Unit
Similar to the pair method of "Building a 2.4G
Wireless Connection", each time you pair the
USB dongle with a new joining unit, you need
to hold the "Pair" buttons on the dongle and
unit at the same time until the link is
established. Select your desired audio source to
play, all the units you paired will sound at the
same time.
USB Dongle
Up to 8
Expanding the System in Multiple
Rooms
To expand your listening areas in other rooms,
install additional units (sold separately) possibly
in bedroom, kitchen and garage, or on the patio
as you prefer.
A single USB dongle can be connected by up to
8 units simultaneously.
Playing back from 2.4G Wireless Audio
Building a 2.4G Wireless Connection
Notes:
l A "receiver" was set in the receiver storage
compartment at the factory.
l The 2.4G wireless connection can be completed
in standby mode or power-on mode.
1. Press the " " button to power on the system
from standby mode.
2. Plug the supplied USB dongle into your device.
(for example, your computer)
l Make sure the supplied USB dongle is well
connected to your device.
l The pair indicator lights up when the unit is
powered on from the standby mode.
3. Launch the music player software if you build
a link with a computer.
4. Select 2.4G wireless sound source by repeatedly
pressing the SOURCE button on the unit or
remote control.
l The pair indicator is solid on before the
connection is built successfully
5. Press the PAIR button on the front panel and
the "Pair" button on the dongle at the same
time until the link is established.
l The pair indicator stars blinking quickly to
indicate that the system and your device
have put into the connection mode.
Supplied Dongle
Dongle
Computer
Pair button
Pair indicator
Blinking
Blinking
LCD Display
Pair Button
PAIR Button
USB Dongle
Main Unit
For SFQ-01W Model ONLY