User's Manual

.15. .16.
B. Auto Scanning - Hold " "/ " " button
until the frequency display starts flashing.
The frequency will be scanned automatically
until a station is found.
4. Hold " " button to start storing a station.
l The channel number shows on the display.
5. Use " "/ " " on the unit or remote control
to select the channel number (from 01 to 20)
to be set.
6. Press " " button again to store the frequency.
The selected frequency will then be stored
with the preset channel number. The display
will be switched automatically to channel
number display after a few seconds.
2. Press the " " button to power on the
system from standby mode.
3. Select tuner mode with the SOURCE button.
4. Select a desired radio station for listening.
5. Move the antenna around to get the best
reception.
6. If necessary, adjust the volume level.
1. Select tuner mode with the SOURCE button.
2. Switch to the frequency display if the display
is channel number.
3. Tune a desired frequency. You can use either
of the below methods to tune the frequency.
A. Manual Tuning - Briefly press " "/ " "
button repeatedly to move frequency to
frequency (from 87.5 MHz to 108.0 MHz)
until you find the desired station.
Listening to Tuner
Listening to a Station
Note: Position the antenna as far away as
possible from the AC adapter, a TV, or other
radiation source.
1. Plug the supplied FM antenna into the
FM.ANT jack located on the back of unit.
Press the Button
Functions
Unit Remote Control
/
l Hold this button to enter saving mode. Press to save a channel.
(see "Presetting a station”)
l Switch between the frequency display and channel number display.
Tune the desired frequency or channel number based on the
different display.
l Select a channel (from 01 to 20).
Presetting a Station
Change frequency from 87.5MHz to 108.0MHz in FM mode.
l Hold for more than one second to activate the Auto Scan function,
and then release the button. The frequency will be scanned
automatically until a radio station is found. Or press again to quit
search while searching.
LCD Display
LCD Display
LCD Display
LCD Display
LCD Display
LCD Display
FM Antenna
Frequency display Channel number display
1. Turn the unit power on.
2. Set the volume to the minimum position.
3. Select AUX mode with the SOURCE button.
4. Start playback on the external device.
5. Adjust the volume level to the level that you
want to listen to.
Note: Volume level will be shown on the display
in the process of adjustment.
Playing back from External Source
Listening to an External Audio
Device, Digital Music Player or Any
Other Audio Source
Connect an external device to the AUX IN jack
on the back panel of the unit using a stereo
mini plug cord (not supplied).
Back Panel
To audio output such
as CD/MD/ digital
music player, etc.