User's Manual

.10.
• The indicator starts blinking quickly to
indicate that the unit and your device have
entered into the connection mode.
• After a Bluetooth connection is established
successfully, the indicator will be solid on.
6. Select the desired music and press "Play"
button on your device. The unit automatically
starts playing back the music.
• Try again above steps 3 to 5 if the pair
indicator starts blinking slowly after 3
minutes, the pair was unsuccessful.
Using Multiple Bluetooth Devices
Only one device can be used at a time, but you
can switch between different Bluetooth devices.
Make sure each device you want to use has
already been paired, to switch devices:
1. On Sound Rise, press the pair button.
2. On Bluetooth device, select the connection to
Sound Rise.
This device is now the connected device to
Sound Rise, (the previous connected device is
now disconnected). Repeat those steps to
switch the connected device again.
Note: If the unit has no sound output, please
check if the volume level of your Bluetooth
device connected to the unit is set to the
minimum, or the Bluetooth device is muted.
Playing back from Macbook or
Macbook Pro
1. In the desktop screen, Select the
“Open Bluetooth Preference”.
2. If there is any old “Sound Rise” records,
remove them. Click the “Continue” button to
proceed pairing process.
3. Once completed, the pairing success
screen will come out.
Note: Don’t quit the page immediately. You
may notice that the previous dialog screen
still shows the device not connected.
Just ignore it. It’s confusing to the user.
In fact, it’s connected already.
4. Open iTune, play a song. Then use the
mouse to click the Bluetooth icon at the top
right hand corner of the desktop screen,
select the “Sound Rise” option and then
select the “Use as Audio Device (Stereo)”.
After a while (a few seconds), the music will
come out from the SFQ-05. If not, select the
“Use as Audio Device (Stereo)” once again.
The Sound Quality should be good.
Playing back from PC/Notebook
1. Press the “Start” button to open the “Device
and Printers” dialog box.
2. Turn on the SFQ-05 system and press the
PAIR button on the unit to put the unit into
the pair mode.
3. Select the “Add a device” in the “Device and
Printer” dialog box. The “Sound Rise” icon
will appear on the display.
4. Double click the “Sound Rise” icon and wait
until the device has been added
successfully.
5. Click the “Close” button to close the “Device
and Printer” dialog box. A ”Sound Rise” icon
appears in the dialog box.
6. Double click the “Sound Rise” icon and the
device connection screen will be shown.
7. Click the “Connect” button in the “Music and
Audio” option.
8. Once connected, the pair indicator on the
unit will be solid on and the connection
success screen will be shown.