Warranty

Page | 7
Step 3:Insert the Spines onto the Full Top Bar and Front Bar
Parts you will need for a 3ft: 3-(e) Spines, 6-(f) Sheet Screws, 1 Drill
Parts you will need for a 4ft: 4-(e) Spines, 8-(f) Sheet Screws, 1 Drill
a) Using a drill and (f) sheet screws, connect the ends of each (e) Spine to the pre-drilled holes on
the (b) Full Top Bar and the (c) Front Bar (with hook extenders). The larger holes on the (e)
Spines will connect to the (c) Front Bar (with hook extenders). Refer to the figure below.
Figure B1:Inserting Spines for a Houstonian 4ft Example
Step 4:Laying out the Right, Middle, and Left Panels onto the Assembled Frame
Parts you will need for a 3ft: 1-(g) Left Panel, 2-(h) Middle Panels, 1-(i) Right Panel, 14 (f) Sheet
Screws, 1- Drill
Parts you will need for a 4ft: 1-(g) Left Panel, 3-(h) Middle Panels, 1-(i) Right Panel, 16-(f) Sheet
Screws, 1-Drill
a) When assembling the panels, start with the (c) Front Bar closest to you. You will lay the panels
down vertically so that the bottom of the panel lies on top of the (c) Front Bar and the top of the
panel lies on top of the (b) Full Top Bar.