Warranty

Page | 8
b) Begin with the (g) Left Panel; the starting panel. Make sure the left side of the (g) Left Panel is
the side/lip hanging down over the (d1) Left Side Frame. This will cover the left side of the
awning frame when the (c) Front Bar is closest to you.Refer to the figures C1 and C2 below.
c) Apply the (h) Middle Panels as shown in the figures below. The panel’s seams, located on the
left side of each (h) Middle Panel, will be set on top of the right side of the panel that was set
before it and will interlock with each other.
d) Finish assembling the panels with the (i) Right Panel. Make sure the right side of the (i) Right
Panel is the side/lip hanging down over the (d2) Right Side Frame. This will cover the right side
of the awning frame when staring at the awning with the(c) Front Bar closest to you.
Figure C1:Layout of Panels for Houstonian 4ft Example
Step 5:Input the Sheet Screws for the Panels
Parts you will need for a 3ft: 14-(f) Sheet Screws, 1- Drill
Parts you will need for a 4ft: 16-(f) Sheet Screws, 1- Drill
a) Now that the panels are in place, you will need to insert the (f) Sheet Screws into the holes and
drill them in. The holes are available on the tops and bottoms of the panel’s edges.
b) First, insert and drill the (f) Sheet Screws into the (c) Front Bar first. Refer to figure D1 below.
c) Second, insert and drill the (f) Sheet Screws into the (b) Full Top Bar. Refer to figure D2 below.
d) Third, insert and drill the (f) Sheet Screws into the (d1) Left Frame and (d2) Right Frame.