Manualshelf

Warranty

ManualsBrandsBeauty-Mark ManualsAwnings8.6 ft. Houstonian Metal Standing Seam Awning (104 in. W x 24 in. H x 36 in. D) in Bronze
12345678910
Page | 9
Step 3:Insert the Spines onto the Full Top Bar and Front Bar
Parts you will need for a 5ft: 5-(e) Spines, 10-(f) Sheet Screws, 1 Drill
Parts you will need for a 6ft: 6-(e) Spines, 12-(f) Sheet Screws, 1 Drill
Parts you will need for a 7ft: 7-(e) Spines, 14-(f) Sheet Screws, 1 Drill
Parts you will need for an 8ft: 8-(e) Spines, 16-(f) Sheet Screws, 1 Drill
a) Using a drill and (f) sheet screws, connect the ends of each (e) Spine to the pre drilled holes on
the attached (b1) Left Top Bar and (b2) Right Top Bar and the attached (c1) Left Front Bar and
(d2) Right Front Bar (with hook extenders). The larger holes on the (e) Spines will connect to the
attached (c1) Left Front Bar (with Hook Extenders) and (c2) Right Front Bar (with hook
extenders). Refer to the two figures below.
Figure B1:Inserting Spines (Houstonian 5ft Example)