Warranty

Page | 16
Step 10: Mounting the Back Bars and Middle Support of the Assembled Awning
to the Surface
Parts you will need for a 5ft: 6-(o) M8 or M6 Anchors, 6-(m) nuts, Drill
Parts you will need for a 6ft: 6-(o) M8 or M6 Anchors, 6-(m) nuts, Drill
Parts you will need for a 7ft: 6-(o) M8 or M6 Anchors, 6-(m) nuts, Drill
Parts you will need for an 8ft: 6-(o) M8 or M6 Anchors, 6-(m) nuts, Drill
a) Drill the pilot holes into the desired surface. Put the (o) anchors into the wall and make sure
they are snug.
b) Mount the tabs of the (j1) Left Back Bar and the (j2) Right Back Bar onto each (o) anchor. Make
sure the anchor is in between the back bar mounting opening.
c) The awning should fit under the combined and assembled (n1) and (n2) Shroud (Hood Cover)
d) Place each (m) Nut on the tip of each (o) anchor and tighten accordingly. Please refer to Figures
H1.
e) Once the back bars are in place, install the flat end of the (q) middle support to the surface by
inserting the anchors.
Figure H1:Mounting the Awning onto the wall