Instructions / Assembly

15
STEP
4
STEP
5
STEP
6
STEP
1
STEP
2
STEP
3
syncing two bases
Unplug base from power source.
Disconnect the power-down box cable from each
control box. Make note where the cable was plugged in.
Connect the male end of the sync cord to each control
box. Insert it into the same port that you disconnected
the control box from in Step 2.
If simultaneous operation of two bases is desired, use the SmartSync™ Cord
to connect the electronics of both bases together.
Connect each power-down box male connection to the
sync cord female connection (Refer to the illustration
below).
Plug base back into the power source.
Check to ensure all cords are securely attached. Both
remotes will now operate both bases simultaneously (If
the remotes become unpaired, see page).
MULTIFUNCTION
6
RESET
PAIRING LED
7
MULTIFUNCTION
6
RESET
PAIRING LED
7
Sync Cord
SplitterSplitter
Control Box Control Box
Power down boxPower down box