BEC 6200WZL 4G/LTE Cellular Broadband Router Quick Start Guide 1
BEC 6200WZL 4G/LTE Cellular Broadband Router PLEASE READ THE QUICK START GUIDE AND FOLLOW THE STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE. IF YOU NEED MORE INFORMATION ON THIS SOFTWARE CONFIGURATION, PLEASE REFER TO THE USER MANUAL ON CD-ROM.
Quick Start Guide Front Panel LEDs LED STATUS DESCRIPTION Green System is up and ready Red Boot failure Green LAN Port is connected to an Ethernet unit, e.g. PC, Notebook, Xbox Blinking Data being transmitted/received Power Ethernet Port LAN 1 ~ 4 Note: port #4 can be configured as WAN port for broadband connectivity Green BEC 6200WZL is successfully connected with a broadband connection device.
BEC 6200WZL 4G/LTE Cellular Broadband Router Rear Panel Connectors 4 3 1 7 1 2 6 PORT 1 8 MEANING LTE Antenna Screw the supplied LTE antennas onto the antenna connectors on both sides. SIM Card Slot Insert the mini SIM card (2FF) with the gold contact facing down. Push the mini SIM card (2FF) inwards to eject it 3 WAN Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the four LAN ports when connecting to a PC or an office/home network of 10Mbps /100Mbps.
Quick Start Guide Hardware Connection Attention Connect the detachable 3G/4G-LTE antennas to the two jacks on the back of the device and make sure they are firmly screwed in. The MAIN antenna connector is used for primary 3G/4G-LTE. If deciding to use ONE antenna, make sure the MAIN antenna connector is being connected at all times. Hardware Installation 1.
BEC 6200WZL 4G/LTE Cellular Broadband Router 3. WAN Link Interface and Connection BEC 6200WZL support dual WAN interfaces, 4G LTE and EWAN. 3.1 4G_LTE Connection Slide the SIM card into the card slot of the device with the gold contact facing down. Make sure that the SIM card has been slid into the bottom of the slot with a click. When removing the SIM card, press the SIM card again it will be ejected from the card slot.
Quick Start Guide Connecting to the Router The default IP of modem is 192.168.1.254 with subnet 255.255.255.0. Make sure the attached PC to this router is in the same subnet and has an IP address in the range between 192.168.1.1 ~ 192.168.1.253. Open a web browser and type http://192.168.1.254 in the URL address bar. URL Address bar: type http://192.168.1.254 The login prompt will appear. Input the default username (admin) and password (admin) for Account type, Administrator.
BEC 6200WZL 4G/LTE Cellular Broadband Router Step 2: WAN / Internet Connection Setup Select the appropriate WAN protocol then fill out the information provided by your ISP in all relevant parameters. For 3G/4G_LTE connection, if your Service Provider is not on the list, please select Other and fill out all of the appropriate fields.
Quick Start Guide 2. You have forgotten your router login and/or password. Try the default login and password, please refer to User Manual. If this fails, you can restore your router to its factory settings by holding the Reset button on the back of your router for 6 seconds or more. 3. Can’t ping any PCs on the LAN. Check the Ethernet LEDs on the front panel. The LED should be on for a port that has a PC connected. If it is off, check the cables between your router and the PC.
