User Guide
114
Navigation Operation
Points of interest (P.O.I.) CD
These instructions contain the general description of the
points of interest (or P.O.I.) CD accompanying the unit.
There are two methods of selecting a point of interest from a
points of interest (P.O.I.) CD:
- During active navigation, a point of interest in the vicinity
of the current position or near to the entered destination
can be selected.
- If navigation is not active, points of interest in the vicinity
of the current position can be selected.
Insert the desired points of interest CD into the CD slot. After
a short time, the following display appears:
Press the right rotary control .
The valid categories for the current points of interest CD are
displayed.
The categories shown here in the illustrations are examples.
The actual display is dependent upon the CD used.
Select the desired category with the right rotary control .
Then, press the right rotary control to confirm the category.
Note: If the set user language is identical with one of the lan-
guages available on the CD, the categories are dis-
played in this language. If there is no correspondence,
the categories are displayed in all available languages.
This can be recognised by the country abbreviations
in front of the category.
If the points of interest CD is inserted during active naviga-
tion, the system requests information on the location of the
point of interest (near to destination or in vicinity of current
position).
If navigation is not active, this selection is skipped.
With the right rotary control, select between
and !!.
After a short time, the available points of interest for the se-
lected categories are displayed.
The arrows following the distance information indicate the di-
rection of the relevant point of interest (e.g. point of inter-
J#
C;
R!I!
!!
!#
OHM
q