Operation Manual

23
GENERAL OPERATION >>>
Cable for vehicle integration
(depending on model, optional)
With a 4-pin 3.5mm jack cable you can
integrate your Navigation device
seamlessly into your vehicle.
• connect your Navigation device to the
phone mute function of your audio
system. If the cable is connected
correctly, your audio system will mute
the car radio during navigation
announcements.
• connect your Navigation device to your
audio system for output of the audio
signal.
> Plug the cable into the designated 3.5
socket on the underside of the device.
Cable for rear view camera
(depending on the model,
optional)
You can connect your rear view camera
to your navigation device using a 4-pin
2.5mm AV cable. Insert the cable into the
socket provided on the back of the basic
unit, also see page 18.
You can make the necessary settings in
the chapter “Rear View camera” on
page 121.
Memory card
Your Navigation device has a slot for a
micro SD memory card.
As the map data is stored in an internal
memory on the Navigation device, the
slot for a micro SD memory card is used
for updates and for viewing images.
The memory card can also be used for
supplementing the map data.
The card slot is located on the bottom
side of the device. The card slot is
equipped with a spring-actuated locking
and ejector mechanism.
Note:
Once the cable is connected, the
loudspeaker of the basic device is
switched off.
GND
Video
Audio-R
Audio-L
GND
Telephone Mute:
Audio-R
Audio-L