User manual

50
>>> NAVIGATION MODE
Displaying the route
Once the address has been entered, the
address input menu allows the route to
the destination to be displayed on the
map.
> Press the
Show route button to display
the route on the map.
The route is calculated.
You can start the route guidance directly
from this screen using the
Start button.
The other options on this screen are
described under „Displaying the whole
route“ on page 81.
Storing a destination
In the address input menu, the
Save
button opens a menu where a name can
be entered for the specified destination.
If the desired name has been entered
and has been pressed to accept it,
the destination is transferred to fast
access mode and protected.
Starting navigation
The
Start button starts the route
guidance.
All data entered thus far is processed
when calculating the route.
> Press
Start to start the route guidance.
>
The route is calculated. The map will
then be displayed and the route guidance
will begin.
If the route guidance is already running
you will be asked whether the new des-
tination should replace the old destina-
tion or if the new destination should be
regarded as a waypoint.
> Select between
Add as stopover, Add
as new destination
or Replace old
destination
.
Note:
The symbols above the progress bar
refer to restrictions that you may have
activated (e.g. unpaved roads, toll
roads).