Operating instructions

12
Assembly and Operating Instructions
9b)
9a)
9c)
10)
10) Learning additional transmitters
Note
In addition to the master transmitter, up to 15 transmitters can be
learnt into the tubular drive system.
Press the learn button of the master
transmitter programmed in 3) for 3 sec-
onds.
The tubular drive makes a “clack”
sound to conrm.
Now press the learn button of a new
transmitter which is unknown to the
tubular drive for 3 seconds. In doing
so, the tubular drive goes into the pro-
gramme mode for a new transmitter for
3 minutes.
The tubular drive makes a “clack”
sound to conrm.
Now press the learn button of the trans-
mitter to be programmed for a further 3
seconds.
The tubular drive makes a “clack-clack”
sound to conrm.
The new transmitter has been pro-
grammed.
9) Ventilation position
Note
This function is used to move your roller shutters from the lower
end limit upwards in order to open the ventilation slats. The ven-
tilation position can only be set after the two end limits have been
set.
9a) Setting the ventilation position
Adjust the shutter into the desired ven-
tilation position.
First press and hold the STOP button.
Within 3 seconds also press the UP but-
ton and keep both buttons pressed.
The tubular drive makes a “clack”
sound to conrm.
The ventilation position has been
stored.
9b) Adjusting the shutters into the ventilation position
Note
The shutters move into the ventilation position from the lower end
limit.
Press the UP button twice within one
second.
The shutter curtain moves into the ven-
tilation position.
9c) Deleting the ventilation position
Adjust the shutter into the ventilation
position.
First press and hold the STOP button.
Within 3 seconds also press the UP but-
ton and keep both buttons pressed.
The tubular drive makes a “clack-clack”
sound to conrm.
The ventilation position has been de-
leted.
Action Response
Clack
Clack
Clack
Clack
Clack
Clack
Clack