Operating instructions

52
>>> NAVIGATION MODE
> D
> GB
> F
> I
> PL
If your entry was not unique or the
Navigation device was not able to
uniquely assign your entry, you will be
shown appropriate lists. You can then
select the address you want from these
lists.
Depending on your entry, lists with town
names, lists with street names or
combined lists with town and street
names can be displayed.
The following example shows a list in
which a town can be selected.
Entries identified with the symbol
open up a further list when they are
selected. This can be necessary if, for
example, the same town name occurs a
number of times in the set country.
Once you have selected the town or
street you want in the lists, the menu for
entering addresses is displayed after a
short time with your entry filled in.
You can then start route guidance,
display the route or store the address as
described on page 49.
Points of interest
Points of interest (POI) are included in the
map and can be displayed there. Points
of interest include airports and ferry
ports, restaurants, hotels, petrol
stations, public buildings. You can use
points of interests as navigation
destinations.
> In the main menu, press the button
New destination.
> Press the
Select Point of Interest
button.
Note:
Voice entry can be restarted at any time
in the lists by pressing the button.
Note:
You can only select points of interest in
the area in question if the GPS reception
is adequate for determining a position.
Otherwise, the last position stored will
be used.
You can extend the places of interest
stored on the device by installing
additional POIs in KML format on your
device via the Content Manager.