User manual
Table Of Contents
- Contents
- Warranty
- Safety instructions
- The Navigation device
- Overview of the scope of Delivery
- Overview of the navigation device
- General operation
- Maintenance and care
- Battery quality declaration
- Display quality declaration
- Start-up
- Power supply
- TMC antenna (depending on the model)
- GPS antenna
- Cable for vehicle integration (depending on model, optional)
- Memory card
- Unit bracket
- Switching the Navigation device on/off
- Basic information about the touch screen
- Basic information about the menus
- Radio remote control
- Content Manager
- Transferring pictures
- Faults
- Navigation Mode
- What is navigation?
- Selecting Navigation
- Last destinations list
- The New destination menu
- Navigation settings
- The Map view button
- The Route overview button
- The Guidance info button
- The Route options button
- Selecting the vehicle profile (depending on model)
- Truck and mobile home functions (depending on model)
- Setting truck profiles
- Selecting vehicle category and name
- Feedback after route calculation
- Zooming in on the map
- Warnings with planned route
- Warnings without planned route
- Selecting the route type
- Time-dependent route guidance
- Avoiding particular types of road
- The TMC button
- The Voice guidance button
- The Warnings button
- The Blocked roads button
- The Vehicle data button
- The Format button
- The Time button
- The Reset button
- Traffic announcements using TMC (depending on the model)
- The map display
- The Route overview
- SituationScan
- Map display options
- Telephone mode
- Tools
- Settings
- Technical terminology
- index
- Model overview and technical specifications
- NOTICE
22
>>> GENERAL OPERATION
> D
> GB
> F
> I
> PL
Inserting the memory card
> Remove the memory card from its
packaging without touching or soiling
the contact bar.
> Hold the memory card so that the
contact strip is facing towards the rear
of the unit.
> Guide the memory card into the card
slot.
> Exert a little pressure and slide the
memory card into the card slot until it
snaps in.
Ejecting the memory card
The card slot ejects the card so that you
can pull it out with two fingers.
> Use your finger to gently press the
memory card against the spring force
into the card slot and then release it.
The card is ejected.
> Remove the memory card and place it
in the packaging while ensuring not to
touch contact bar.
Unit bracket
The Navigation device can be attached
directly to the windscreen with the unit
holder.
Fitting the unit bracket
Note:
The Navigation device and unit bracket
must not be exposed to long periods of
direct sunlight. Temperatures inside the
vehicle of +70 °C and higher may
damage parts of the bracket.
Note:
Fasten the unit holder such that your
field of vision is not impaired when the
Navigation device is installed and
ensure that the unit is outside the
deployment area of the airbag.
Ensure that the electrical connection
cable does not hamper you from
accessing the vehicle's controls.
Clean the attachment surface on the
windscreen to ensure that it is clean and
free of grease. Do not use greasy or
soapy cleaning agents.