User manual
Table Of Contents
- Contents
- Warranty
- Safety instructions
- The Navigation device
- Overview of the scope of Delivery
- Overview of the navigation device
- General operation
- Maintenance and care
- Battery quality declaration
- Display quality declaration
- Start-up
- Power supply
- TMC antenna (depending on the model)
- GPS antenna
- Cable for vehicle integration (depending on model, optional)
- Memory card
- Unit bracket
- Switching the Navigation device on/off
- Basic information about the touch screen
- Basic information about the menus
- Radio remote control
- Content Manager
- Transferring pictures
- Faults
- Navigation Mode
- What is navigation?
- Selecting Navigation
- Last destinations list
- The New destination menu
- Navigation settings
- The Map view button
- The Route overview button
- The Guidance info button
- The Route options button
- Selecting the vehicle profile (depending on model)
- Truck and mobile home functions (depending on model)
- Setting truck profiles
- Selecting vehicle category and name
- Feedback after route calculation
- Zooming in on the map
- Warnings with planned route
- Warnings without planned route
- Selecting the route type
- Time-dependent route guidance
- Avoiding particular types of road
- The TMC button
- The Voice guidance button
- The Warnings button
- The Blocked roads button
- The Vehicle data button
- The Format button
- The Time button
- The Reset button
- Traffic announcements using TMC (depending on the model)
- The map display
- The Route overview
- SituationScan
- Map display options
- Telephone mode
- Tools
- Settings
- Technical terminology
- index
- Model overview and technical specifications
- NOTICE
32
>>> GENERAL OPERATION
> D
> GB
> F
> I
> PL
> Position the base plate so that the
word UP is pointing in the direction of
travel.
> Secure the base plate using the
supplied screws or self-adhesive film.
> Press the remote control onto the
base plate.
> Hold the bottom part of the remote
control and turn the remote control
clockwise until it locks into place.
Removing the remote control
You can remove the remote control
again, to change the battery for example.
> Hold the bottom part of the remote
control and turn the remote control
anti-clockwise until it becomes
detached from the base plate.
Note:
If you wish to stick the base plate in
place, you will first need to clean the
adhesive surfaces.