User manual
Table Of Contents
- Contents
- Warranty
- Safety instructions
- The Navigation device
- Overview of the scope of Delivery
- Overview of the navigation device
- General operation
- Maintenance and care
- Battery quality declaration
- Display quality declaration
- Start-up
- Power supply
- TMC antenna (depending on the model)
- GPS antenna
- Cable for vehicle integration (depending on model, optional)
- Memory card
- Unit bracket
- Switching the Navigation device on/off
- Basic information about the touch screen
- Basic information about the menus
- Radio remote control
- Content Manager
- Transferring pictures
- Faults
- Navigation Mode
- What is navigation?
- Selecting Navigation
- Last destinations list
- The New destination menu
- Navigation settings
- The Map view button
- The Route overview button
- The Guidance info button
- The Route options button
- Selecting the vehicle profile (depending on model)
- Truck and mobile home functions (depending on model)
- Setting truck profiles
- Selecting vehicle category and name
- Feedback after route calculation
- Zooming in on the map
- Warnings with planned route
- Warnings without planned route
- Selecting the route type
- Time-dependent route guidance
- Avoiding particular types of road
- The TMC button
- The Voice guidance button
- The Warnings button
- The Blocked roads button
- The Vehicle data button
- The Format button
- The Time button
- The Reset button
- Traffic announcements using TMC (depending on the model)
- The map display
- The Route overview
- SituationScan
- Map display options
- Telephone mode
- Tools
- Settings
- Technical terminology
- index
- Model overview and technical specifications
- NOTICE
50
>>> NAVIGATION MODE
> D
> GB
> F
> I
> PL
If the route guidance is already running
you will be asked whether the new
destination should replace the old
destination or if the new destination
should be regarded as a waypoint.
> Select
Add as stopover or Replace old
destination.
If the route guidance is already running
and a waypoint has already been entered
you will be asked whether the new
destination should replace the old
destination or the waypoint.
> Select
Replace stopover or Replace
old destination.
Note:
The symbols above the progress bar
refer to restrictions that you may have
activated (e.g. unpaved roads, toll
roads).
The symbol next to the progress
bar indicates that the time-dependent
route guidance described in "The Route
options button" on page 69 is active.
(depending on the model)
Note:
If there is no GPS signal when the route
is calculated, the following will be
displayed:
When a GPS signal is available, the route
calculation will start automatically.
When the
Last position button is
pressed, the last known position is used
and the route calculated from this
position.