User manual
Table Of Contents
- Contents
- Warranty
- Safety instructions
- The Navigation device
- Overview of the scope of Delivery
- Overview of the navigation device
- General operation
- Maintenance and care
- Battery quality declaration
- Display quality declaration
- Start-up
- Power supply
- TMC antenna (depending on the model)
- GPS antenna
- Cable for vehicle integration (depending on model, optional)
- Memory card
- Unit bracket
- Switching the Navigation device on/off
- Basic information about the touch screen
- Basic information about the menus
- Radio remote control
- Content Manager
- Transferring pictures
- Faults
- Navigation Mode
- What is navigation?
- Selecting Navigation
- Last destinations list
- The New destination menu
- Navigation settings
- The Map view button
- The Route overview button
- The Guidance info button
- The Route options button
- Selecting the vehicle profile (depending on model)
- Truck and mobile home functions (depending on model)
- Setting truck profiles
- Selecting vehicle category and name
- Feedback after route calculation
- Zooming in on the map
- Warnings with planned route
- Warnings without planned route
- Selecting the route type
- Time-dependent route guidance
- Avoiding particular types of road
- The TMC button
- The Voice guidance button
- The Warnings button
- The Blocked roads button
- The Vehicle data button
- The Format button
- The Time button
- The Reset button
- Traffic announcements using TMC (depending on the model)
- The map display
- The Route overview
- SituationScan
- Map display options
- Telephone mode
- Tools
- Settings
- Technical terminology
- index
- Model overview and technical specifications
- NOTICE
94
>>> NAVIGATION MODE
> D
> GB
> F
> I
> PL
Map orientation
When a route is activated, the map view
can be oriented in different ways.
If you have selected a 2D view in the
Navigation settings in the map view (see
page 64), this pertains to the compass
direction only.
> Press the 2D map view on the display
a little longer.
Apart from the pulsating point, a
compass and two arrow buttons pointing
to the left and right appear on the top
edge of the screen.
> Press the and buttons to
rotate the map towards the desired
compass direction.
You can orient the map for example in
the direction of travel.
If you have selected a 3D display for the
map view, the vertical display angle can
be adjusted, too.
> Press the 3D map view on the display
a little longer.
Apart from the pulsating point, a com-
pass and two arrow buttons and
pointing to the left and right appear on
the top edge of the screen, and on the left
edge of the screen, two arrow buttons
pointing up and down are displayed.
> Press the button.
The viewing angle will be lower and the
horizon is moved back after a while into
the image.
> Press the button.
The viewing angle will be steeper. If the
angle is exactly 90°, you are viewing the
map in the 2D view from the top.
The Route overview
With the Route overview, you can have
Points of Interest (POIs) and, if the TMC
on route option is activated in the
Navigation settings > Route overview
menu, TMC events displayed on the
selected route.
> Press the button.
A list of POIs and traffic events are
displayed. In the top edge of the screen,
four single buttons are displayed for TMC
announcements on the route and the
three selected POI Categories are also
displayed. Apart from the symbols, the