User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Remove windscreen in the dir-
ection of arrow.
Unclip air inlet flap at the top
in the direction of arrow and
remove downwards.
Disconnect connector for right
turn indicator 1 and left turn
indicator 2.
NOTICE
If the mirrors with integrated turn
indicators are removed in pre-
paration for a race-track session,
the vehicle electronics detect a
defective light and the appropri-
ate warning message appears
on the display. Deactivating the
Light warnings function in the
RACETRACK CONFIGURATION
menu suppresses this warning
message.
Remove nuts 1 and 2 on the
left and right and remove mir-
rors.
Carefully thread out cable.
Secure fairing 1 at the left and
right fairing bracket 2. If cable
straps are used, protect any
8
148
z
On the race track