User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Clamping bolts in wheel
axle clamp
Tightening sequence: Tighten
screws six times in alternate
sequence
19 Nm
Place brake calliper on the
brake discs.
Place brake caliper 2 on left
and position cable routing 3.
Install bolts 1 and tighten to
the specified torque.
Radial brake caliper on
wheel axle clamp
38 Nm
Secure cable for wheel speed
sensor in holder 1.
Insert wheel speed sensor in
the bore hole and secure with
bolt 2.
10
193
z
Maintenance