User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Lift the rear wheel and work
quick-release axle 2 through
the adjustment plate and into
the brake-caliper support and
the rear wheel.
Make sure that the quick-re-
lease axle fits into the recess
for the flats.
Insert left adjustment plate 1.
Install axle nut 2 with washer,
but do not tighten it at this
point.
Adjust chain sag ( 208).
Lighting
Replacing LED light
sources
WARNING
Vehicle overlooked in traffic
due to failure of the lights on
the vehicle
Safety risk
Always replace a faulty bulb at
the earliest possible opportun-
ity. Consult a specialist work-
shop, preferably an authorised
BMW Motorrad Retailer.
All light sources of the vehicle
are LED light sources. The
service life of the LED light
sources is longer than the
presumed vehicle service
life. If an LED light source
is faulty, please contact a
specialist workshop, preferably
an authorised BMW Motorrad
Retailer.
Body panels
Remove the side panel
NOTICE
The procedure described here
for the right side apply applies by
analogy to the left side panel.
Place the motorcycle on its
stand on firm, even ground.
Remove screws 1.
Remove screws 2.
10
197
z
Maintenance