User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Checking chain sag
Place the motorcycle on its
stand on firm, even ground.
Turn the rear wheel until it
reaches the position with the
lowest amount of chain sag.
Use a screwdriver to push
the chain up at a point mid-
way between the pinion and
sprocket and measure differ-
ence A.
Chain deflection
45...50 mm (Motorcycle with
no weight applied, supported
on its side stand)
If measured value is outside per-
mitted tolerance:
Adjust chain sag ( 208).
Adjust chain sag
Place the motorcycle on its
stand on firm, even ground.
Loosen quick-release axle
nut 1.
Loosen lock nuts 3 on left and
right.
Use the adjusting screws 2 on
left and right to adjust chain
sag.
Checking chain sag ( 208).
Make sure that the scale val-
ues 4 are the same on the left
and right.
Tighten lock nuts 3 on left and
right to the specified tightening
torque.
Locknut of the final-drive
chain tensioning screw
19 Nm
Tighten quick-release axle
nut 1 to the specified tight-
ening torque.
Rear quick-release axle
in swinging arm
Thread-locking compound:
mechanical
100 Nm
10
208
z
Maintenance