User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Values display
The symbols 4 displayed vary.
Different colours are used de-
pending on assessment. In-
stead of numerical values 8 with
units 7, texts 6 are displayed:
Colour of the symbol
Green: (OK) current value is
optimum.
Blue: (Cold!) current tempera-
ture is too low.
Yellow: (Low! / High!) current
value is too low or too high.
Red: (Hot! / High!) current
temperature or value is too
high.
White: (---) valid value not
available. Instead of the value,
dashes 5 are displayed.
NOTICE
The assessment of some values
is only possible from a certain
journey duration or speed. If a
measured value is still not being
displayed because the conditions
for measurement have not been
met, dashes are displayed in-
stead as a placeholder. If there
are no valid measured values,
there will be no assessment in
the form of a coloured symbol.
Check Control dialogue
Messages are output as a Check
Control dialogue 1.
If several CC messages with
the same priority are present,
the messages alternate in the
order they occurred until these
are acknowledged.
If the symbol 2 is actively being
displayed, it can be acknow-
ledged by holding the Multi-
Controller to the left.
Check Control messages are
dynamically attached as addi-
tional tabs on the pages in the
menu My vehicle ( 87).
You can go to the message
3
33
z
Status indicators