User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Seek the advice of a specialist
workshop, preferably an author-
ised BMW Motorrad Retailer.
Possible cause:
Plug connection disconnected.
Connect disconnected plug
connection. ( 157)
Side stand monitoring is
faulty
Side stand monitor-
ing faulty. Onward
journey possible. Engine
stop. when stationary!
Have checked by workshop.
Possible cause:
The side-stand switch or its wir-
ing are damaged.
Seek the advice of a specialist
workshop, preferably an author-
ised BMW Motorrad Retailer.
ABS self-diagnosis not
completed
ABS indicator and warning
light flashes.
Possible cause:
ABS self-diagnosis not
completed
The ABS function is not avail-
able because self-diagnosis
did not complete. (The motor-
cycle has to reach a defined
minimum speed for the wheel
sensors to be checked: min
5 km/h)
Pull away slowly. Bear in mind
that the ABS function is not
available until self-diagnosis has
completed.
ABS deactivated
ABS indicator and warning
light comes on.
Possible cause:
The rider has switched off the
ABS system.
Activating the ABS function
( 156).
ABS fault
ABS indicator and warning
light comes on.
Limited ABS availab-
ility! Riding at mod.
speed pos. Ride carefully
to next specialist work-
shop.
Possible cause:
The ABS control unit has
detected a fault. The partially
integral function and the
Dynamic Brake Control function
have failed. The ABS function
has limited availability.
You can continue to ride. Take
note of the more detailed in-
formation on certain situations
3
51
z
Status indicators