OWNER’S MANUAL HEAD FOOT SNORE TV 1 2 Z-G LPB11NM Rev 1.
Setup the power foundation without the bed frame. 1 Open the box lid. D HEA D 2 Take out all the accessories from the packaging and put them aside. Mattress Retainer Bar R BOA ×1 ACCESSORIES BOX: Adjustable Legs Remote Control HEAD Accessories Box ×1 3 Install 4 legs. D HEA D R BOA 4 D HEA Slat/ Platform Legs ×6 Remove the bed from the box with a flipping motion, let the bed stand on the 4 legs.
6 ARD 7 Install the remaining 2 legs on the foot end of the bed. Uncoil the DC power cord (connected to the control box) and put it to the side of the bed. O DB HEA D HEA D R BOA Make the bed completely flat. Control Box 8 Install the mattress retainer bar one side after another. 1 2 9 Insert the batteries into the remote control. Uncoil the AC power cord, connect the DC power cord to the power supply and then connect the power supply to the AC power source.
Setup the power foundation with the bed frame and slat base. 1 Take the bed out of the box, put it on the slat base, do not install any legs. Uncoil the DC power cord (connected to the control box)， pull the DC power cord towards the direction of the AC power source through either the bottom or the side of the bed frame. D HEA 2 Make the bed completely flat with a flipping motion.
Lift the head and foot end of the bed by remote control. Install the four stabilizer brackets as shown. M8*16 Bolts D Washers HEA D R BOA Parts List HEAD FOOT SNORE TV 1 2 Z-G INCLUDED WITH POWER FOUNDATION (1)Remote Control FOOT SNORE TV 1 2 (3)AAA Batteries (4) Stabilizer Brackets (1)Socket Wrench 9V HEAD (1)AC Power Cord Z-G 9V 9V (optional) Screws ST4.2×16 Sync Cord (1) (TXL Only) DONE! Add Additional Leg Supports For Slat/Platform Bed Frames.
Electronics Quick Reference Guide Sync Cord LED UNDERNEATH LED LIGHTING Remote Control WIRELESS RECEIVER Home Position HEAD FOOT SNORE TV 1 2 Z-G LED APP SYN CB11B Control Box HD Motor FT Motor USB HEAD FOOT Lifts and Lowers Foot Z-G Zero G Preset Position TV Position Anti-Snore Preset Position Programmable Positions SNORE TV 1 2 ONE TOUCH BUTTON Under Bed LED on/off One touch flat position.
Headboard Bracket Installation Guide(Optional) Pairing Remote HEAD FOOT SNORE TV 1 2 Headboard brackets are optional and not included. A 1/2” (13 mm) socket and 1/2” (13 mm) wrench are required to complete the installation. Z-G (2) Headboard Brackets (2) T-Brackets (8) M8*16 (4) Nuts (4) Washers STEP 1：Make sure the batteries are good. Replace them when needed. STEP 2：Unplug the power cord from the power source. If 9V backup batteries were installed in the power supply, remove them.
Bedgear Mobile APP（Optional） Before you start. Switch on the pairing function on your mobile device. Make sure your Bedgear Power Foundation is correctly connected and is power-on. Bedgear Bedgear The Bedgear APP will automatically pair your Bedgear Power Foundation once you start the APP and does not require additional settings. The Bedgear Mobile APP uses the latest technology to communicate with your Bedgear Power Foundation.
