User's Manual

USER MANUAL – MODEL 3 SKU: 3S-800NA
QUESTIONS? EMAIL [e-mail] OR CALL 401-404-5250
WE ARE HERE TO HELP – PLEASE CALL US FOR ADVICE!
Revision 1.0 www.bedjet.com P a g e | 18
HELP! DON’T LIKE FEELING THE AIR BLOWING UNDER THE COVERS?
Don’t blow BedJet air directly into your sleeping layer. Try adjusting Air Nozzle to inject air
above your top sheet instead of below it and make sure you have another tightly knit layer of
bedding above the Air Nozzle to guide the air through a sandwiched layer. An even better
solution is use of the Cloud Sheet, which dramatically improves distribution of the air and
reduces the feeling of air movement.
HELP! COOLING FELT ONLY ON YOUR FEET AND NOT ON BODY?
The BedJet requires a good quality top sheet or comforter of generally 250 thread count or
higher to keep the cooling air trapped and circulating in the bed. Feet-only cooling results from
use of a top sheet that is not compatible with the BedJet or use of no top sheet at all or just a
loose-knit blanket. At 100% airflow your bed should have nearly all of your bedding ballooning
slightly off the bed and air flow will be felt exiting at the very top of the bed from under the top
sheet. You should be able to feel the cooling air on your torso. If this is not occurring, then
your top sheet is too breathable or too low a thread count. Performance “cooling” sheets,
highly breathable loose knit sheets, jersey knit type sheets and blankets without any top sheet
let all the air out at the bottom of the bed before it can circulate to the top of bed properly.
Solution: Change top sheet types or utilize the BedJet Cloud Sheet.
Heating Mode - Tips for Better Enjoyment
Turbo Heat mode is best used as a pre-heater for warming your bed very quickly before
getting into bed, or for single short bursts while in bed. Turbo Heat pumps the maximum
amount of heat into the bed with the maximum amount of airflow and can warm the
temperature of your bedding by up to 30 °F (17°C) above ambient in just five minutes.
This mode has a very short default Auto-Shutoff time of 5 minutes, as the warmth
generated and noise levels are too powerful for extended use or comfortable sleeping.
You can extend the shutoff time to maximum of 10 minutes.
• Do not continuously re-cycle the BedJet into Turbo-Heat mode while in bed.
• Do not place body parts directly into or in front of Air Nozzle in Turbo Heat mode.
• TURBO HEAT MODE IS SOFTWARE LIMITED TO 10 MINUTES OPERATION
OUT OF EVERY 30 MINUTES. ATTEMPTS TO CONTINUE OPERATION
BEYOND THIS LIMIT WILL CAUSE AUDIBLE BEEPING AND BEDJET WILL
DEFAULT TO REGULAR HEAT MODE.