Installation Manual

9. Attach sidewall panels to truck bed.
Begin by attaching the front edge of the side
panel to the Bulkhead Panel. Be sure the 2"
wide hook is secure against the fabric side of
the side panel.
It is best to center and attach the wheel well
area next. Clean attachment areas of bed with
alcohol and let dry. Remove backing tapes
and adhere to truck.
Work from the bottom up then toward the front
and rear.
Repeat with the opposite sides.
Press all fasteners firmly in place.
Procedure
BedTred Truck Bed Liner Installation Instructions
ULTRA
10. Prepare BedTred Tailgate Panel
Attach 1x60 Hook Fasteners to both the top
and bottom edge of tailgate as shown.
11. Attach Tailgate Panel to Truck
If your truck has a plastic tailgate cap, you
must do ONE of the following options to
ensure proper fit of Tailgate Panel.
Lay Tailgate Panel onto tailgate and observe
where the upper edge meets the tailgate cap.
IF the Tailgate Panel DOES overlap the plastic
tailgate cap, clean the cap with alcohol and apply
Adhesive Promotor before attaching Hook
Fastener.
IF Tailgate Panel does NOT overlap the plastic
tailgate cap, discard the Adhesive Promoter and
proceed with remainder of installation procedure.
Tailgate Cap
SHOWN DETACHED FROM FLOOR PANEL
FOR CLARITY
UTINST Rev. 1 7/27/2016
Page 4 of 6