User Manual

11ASSEMBLY INSTRUCTIONS FOR TROLLEY
ASSEMBLY INSTRUCTIONS
FOR TROLLEY
Test gas pressure by removing the last burner from the
left hand side of the barbecue and attaching a hose and
pressure gauge to the end of the gas valve�Turn on 2
burners and check the pressure�Inlet pressure should be
11�0” WC or 2�75 kPa�
Fixed Installation - Natural Gas
(Natural Gas installation should be carried out by a qualified
gas fitter)�
BeefEater Natural Gas barbecues are designed as low-
pressure appliances (4�0” WC, 1�00KPa)�
Fit the natural gas regulator supplied directly to the
barbecue inlet located on the right side of the appliance
using either hard plumbing, or a flexible hose connected to
a bayonet point, also known as a quick connect fitting�Refer
to AS 5601 or your local installation code for pipe sizing
details�Secure all joints spanner (wrench) tight but do not
over-tighten�
Test gas pressure by removing the last burner from the
left hand side of the barbecue and attaching a hose and
pressure gauge to the end of the gas valve�Turn on 2
burners and check the pressure�Inlet pressure should be
4�0” WC or 1�00 kPa�
Australia only (applies to all gas types) : Where a mobile
appliance is to be connected to a fixed gas supply via a
flexible hose connection, a retaining tether of adequate
strength shall be fixed to the appliance and be suitable to
be fixed to the wall within 50mm of each connection
point� The length of the tether shall not exceed 80% of the
length of the hose assembly� In this way, if the barbecue
is accidentally moved, the chain stops the barbecue from
stretching the hose�
The barbecue appliance must be isolated from the gas
supply piping system by closing its manual shutoff valve
during any pressure testing of the gas supply piping system�
Before You Start
Note the tools you will need before you begin�
Check for damaged or missing parts, and consult your
retailer if necessary�
Many components and panels are covered with a protective
sheet of plastic� You will need to remove this plastic covering
from all surfaces, especially where two panels join� It is
a good idea to leave some plastic on the panels during
assembly to protect the stainless steel during the assembly
process� Ensure however that all plastic covering is removed
on completion�
Always assemble on a clean, smooth, flat working surface
that will not scratch the surface of the stainless steel�
Allen Key Adjustable
spanner/
wrench
Phillips head
screwdriver
1) Fit The Fixed Castors
Fit the fixed castors into the holes in the bottom of the base�
At this step, use only two Allen head screws, washers and
nuts for each castor in the positions shown� The two outside
screws will be put on in step 3�
Spanner/wrench tighten immediately�
Note lip
ends here