Installation manual

Setting Up the System Service User Menu
30 Apr 2004
6
After inserting the IMN number and pressing

the
handset will show “ID” and a number. The ISP may also
have indicated the corresponding ID along with an IMN-
number.
If the ID shown by the terminal corresponds with the ID
given by the ISP press

. If not, then press

to
correct the ID, type in the correct ID and confirm with

.
If the ISP has not indicated the ID for each IMN number
two situations exist:
1) If there is not more than one IMN-number pr. service
and the IMN list is empty, the ID shown by the terminal will
always be correct and thus just press
.
2) If there is more than one IMN-number pr. service and
the IMN list is empty, the rule is that the first (or upper)
IMN on the returned commissioning form will have the
lowest ID and each subsequent IMN-number will have an ID
which is 1 higher than the predecessor.
Note: In case the IMN’s are combined with the wrong
ID’s, the wrong interface may be activated for
incoming calls. Furthermore, reference IMN for a
hardware interface when making outgoing will be
wrong. Thus service type and billing will be otherwise
than expected. The ISP may help you with this.
ID’s are entered as decimal and the allowed range pr.
service type is as follows:
Service ID – range
Mini-M Voice 1 – 15
9600 Fax 17 – 31
9600 Data 33 – 47
MPDS 161 – 175