Operation Manual
19
EN Multi-Star 3 in 1
BEEM - Elements of Lifestyle
CAUTION
Only operate the appliance when the ►
upper part is folded down.
Do not operate the appliance when it ►
is empty.
Do not pull the connecting cable ►
to remove the plug from the mains
socket.
Do not use hard objects or abra- ►
sive cleaning agents to clean the
surfaces.
Never lift or move the appliance with ►
the mains cable.
Requirements for the place of use
For safe and trouble-free operation of the
appliance, the installation location must
satisfy the following requirements:
Place the appliance on a rm, dry, at, ■
waterproof and heat-resistant surface.
Do not install the appliance in a hot, ■
wet or very humid environment.
The mains socket must be easily ac- ■
cessible and allow fast disconnection
in the event of an emergency.
The surface nishes on furniture may ■
contain substances that can be detri-
mental to the silicon feet of the appli-
ance. If necessary, place a mat under
the feet of the appliance.
Allow enough room around the appli- ■
ance so that air can circulate freely.
Select a location that does not allow ■
children to reach the hot surfaces of
the appliance.
Electrical connection
For safe and trouble-free operation of the
appliance, the following instructions must
be observed for the electrical connection:
Before connecting the appliance, ■
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. This
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
The mains socket must be protected ■
by at least a 10 A automatic circuit
breaker.
Ensure that the mains lead is undam- ■
aged and is not laid over sharp edges.
The mains cable must not pulled ■
tightly, bent or come into contact with
hot surfaces.
Always unwind the mains cable com- ■
pletely before connecting the appliance
to the mains socket.
Route the cable to prevent risk of trip- ■
ping.
The electrical safety of the appliance ■
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualied
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.